JWELL High Pressure RTP Twisted Composite Pipe Extrusion Line

This RTP extrusion line produces three-layer PE100 pipe with a selectable wound reinforcement structure for high-pressure service.

نقاط البيع الرئيسية

• بناء ثلاثي الطبقات: Forms a PE100 liner, wound reinforcement layer, and protective PE100 outer layer.
• Reinforcement Choice: Supports synthetic, glass, carbon, aramid, metal-strip, and fine-wire reinforcement.
• تصميم عالي الضغط: Aramid RTP is stated at up to 9-14 MPa working pressure.
• Diameter Coverage: Source models cover pipe diameters from 63 mm to 315 mm.
• Model-Based Output: Source output ranges extend from 120 to 500 kg/h.

بيانات المعدة

سيناريو التطبيق

وصف المنتج*

The High-Pressure Reinforced Thermoplastic Pipe Production Line is configured to manufacture three-layer RTP pipe with a protective thermoplastic structure and a wound reinforcement core. The inner layer is made from corrosion-resistant, wear-resistant PE100 pipe, while the outer PE100 layer protects the reinforcement during handling and service. Between these layers, the line forms the reinforced winding layer that gives the finished pipe its pressure-bearing structure.

Purchasers can select the reinforcement according to the intended pipe design. The source document supports high-strength synthetic fiber, glass fiber, carbon fiber, metal strip, fine metal wire, and aramid fiber as winding materials. This range enables the equipment specification to be aligned with the required reinforcement system without changing the basic three-layer construction.

For aramid-fiber-reinforced RTP, the document states a working-pressure range of up to 9-14 MPa and a burst pressure of up to 40 MPa. These pressure figures apply specifically to aramid reinforcement and should be confirmed against the customer’s pipe design, raw materials, and acceptance requirements before ordering.

Three line models cover stated pipe diameters from 63 mm to 315 mm. Source-rated maximum output ranges extend from 120-300 kg/h to 300-500 kg/h, depending on the model. Because current JWELL literature differs from the supplied document for selected extruder, output, and installed-power values, the complete source table is retained below with confirmation notes. Buyers should finalize model selection and technical parameters directly with JWELL before quotation or production planning.